Airplane mode gets a device in a state where all the wireless connections of the devices go out. However, some reports tell us that Airplane mode is enabled by itself in Windows 10. This may be due to a network driver error, conflicts with third parties, and so on. The other errors that end up in the same umbrella are those where the airplane mode is flashing automatically or when you can not switch the Airplane Mode option.
Airplane mode activates itself in Windows 10
The following methods have been shown to be effective in solving this airplane mode problem in Windows 10:
- Configure the power management settings for the driver.
- Use the network troubleshooter.
- Restore, reinstall, or update the network driver.
- Troubleshoot in the clean boot state.
1) Configure power management settings for the driver
Open the device manager. Develop Network Adapters
Select the input corresponding to your WiFi hardware and click on it with the right mouse button. properties.
Go to Management of the food tab and uncheck the Allow the computer to turn off this device to save power option.
2) Use the network troubleshooter
The problem may also be due to a problem with the NIC settings. Use the network adapter troubleshooting utility to correct the error.
3) Restoring, reinstalling, or updating the network driver
The drivers listed in the section of Network Adapters Inside Device Manager can be a cause for this particular. You can try to reinstall network drivers from your motherboard. If you have recently updated these drivers, cancel and consult. If you have not done so, we suggest you update these drivers.
4) Troubleshooting in a clean boot state
You can resolve the problem manually by performing a clean boot. A clean boot starts a system with a minimal number of drivers and startup programs. When you start the computer cleanly, the computer starts by using a minimal set of drivers and pre-selected startup programs. Some programs may not work properly, because the computer starts with a minimal number of drivers.
Minimal troubleshooting is designed to isolate a performance problem. To perform a clean troubleshooting, you must disable or enable one process at a time, and then restart the computer after each action. If the problem goes away, you know it was the last process that created the problem.
In this way, you can find the paid process or service with the Airplane Mode button.
Good luck!